Go Back   6th Gen Accord DIY and Performance Forums > The Garage > Accord Tech

Accord Tech Anything tech-related that doesn't necessarily fit in the other forums. CEL Codes, torque specs, etc all go in here

Register to remove these ads


Reply
 
Thread Tools Search this Thread
  #1  
Old 10-08-2018, 08:25 PM
camjohns camjohns is offline
Junior Member
Points: 7,556, Level: 26 Points: 7,556, Level: 26 Points: 7,556, Level: 26
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Feb 2012
Location: ashland ohio
Posts: 25
Rep Power: 0
camjohns is an unknown quantity at this point
3.0 v6 stalls when engine bay is wet

Searching through various forums, I have found that this is a common thing with Accords.

I find that if I wash the engine bay out, my car will stall, and then for the next couple of days will continue to stall while driving until it completely dry's out. I find that if I am able to keep the RPMs up while driving it does ok, but when stopping stalls and dies.

When it is dry, drives completely normal.

I do have a cold air intake, but is not wet when i was it out.

here is what I have done (some things were needing to be done)

1. replaced the dead main relay
2. going to replace the ignition switch
3. cleaned out the IACV

going to complete
1. completely cleaning intake manifold.

I'm assuming something electrical is getting wet but figured I would post here before diving in too much if there is something that is obvious that is typically the culprit.

I figured my next steps are to get certain parts of the engine bay wet and isolate from there.

any thoughts appreciated!
Reply With Quote
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


» Featured Ride
CHECK OUT THIS WEEK'S FEATURED RIDE!



Powered by vBadvanced CMPS v3.2.3