Go Back   6th Gen Accord DIY and Performance Forums

Register to remove these ads


View Single Post
  #60  
Old 09-14-2011, 01:02 AM
AZmike AZmike is offline
Member
Points: 3,448, Level: 16 Points: 3,448, Level: 16 Points: 3,448, Level: 16
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Aug 2011
Location: Tucson, AZ
Posts: 48
Rep Power: 0
AZmike is somewhat reliable
Re: Sway Bar Sizes

Originally Posted by GoldnKnight22 View Post
Yes, everything listed fits all 6th gen Accords.

Not 100% positive if the TL RSB is solid... when I remove mine, I'll examine it but there won't be any way to tell...
Sure there's a way to tell.

I weighed my stock 16 mm rear sway bar and the 20 mm TL rear sway bar when I swapped it out. They're both solid. Here's how I'm sure:

For the 16 mm:

Measured mass 2.240 kg
1.36 m bar length without ends

Assume the bar is solid
ends: ~0.06 kg (based on volume estimate) each
bar: 1.36m*0.016^2*pi/4 *7850 kg/m^3 = 2.15 kg

Estimated mass if solid 2.15+0.12 = 2.27 kg

That's less than 2% off the measurement--it's solid.

The same math works for the 20 mm bar: 3.430 kg measured, 3.47 kg estimated, <1% error
Reply With Quote
 
» Featured Ride
CHECK OUT THIS WEEK'S FEATURED RIDE!



Powered by vBadvanced CMPS v3.2.3